Panasonic Industry / Automation Controls
MENU
Panasonic Industry / Automation Controls

ER-VW｜Thin-type Ionizer ER-VW

Download

*Photo may vary from actual product.

This product has been confirmed that it does not contain the 6 substances specified in EU RoHS Directive 2011/65/EU and the 4 substances specified in 2015/863/EU.

Product Number

ER-VW

Part Number

ER-VW

Product

Thin-type Ionizer

Details

Spot type

Product Name

 Thin-type Ionizer ER-VW

Contact Us

*Specifications and design of the products are subject to change without notice for the product improvement.

Spec Detail

Specifications and design of the products are subject to change without notice for the product improvement.
ItemSpecifications
Part NumberER-VW
Product NumberER-VW
Products NameThin-type Ionizer
Product detailsSpot type
The price of the productPlease contact our office
Charge removal time1 sec. or less (plus or minus1,000 V to plus or minus100 V)
(Note) A typical sample applied with a supply voltage of 24 V, a distance of 100 mm 3.937 in from the front surface of the air flow outlet and a pressure of 0.25 MPa. (Measured on a sample left in the atmosphere at a relative humidity of 65 % RH or less for 24 hours or more.)
Ion balanceplus or minus10 V or less
(Note) A typical sample applied with a supply voltage of 24 V, a distance of 100 mm 3.937 in from the front surface of the air flow outlet and a pressure of 0.25 MPa. (Measured on a sample left in the atmosphere at a relative humidity of 65 % RH or less for 24 hours or more.)
Ozone generation0.05 ppm or less
(Note) A typical sample applied with a supply voltage of 24 V, a distance of 300 mm 11.811 in from the front surface of the air flow outlet and a pressure of 0.25 MPa.
Applicable fluidAir (dried clean air)
(Note) Dry clean air is air that has been processed through an air dryer (freezing point around –20 ℃ –4 ℉) and an air filter (mesh size around 0.01 microm 0.0004 mil).
Supplied air flow60 liter/min. (ANR) or less
Air pressure range0.05 to 0.5 MPa
Supply voltage24 V DC plus or minus 10 %
Current consumption120 mA or less
Discharge methodHigh frequency AC method
Discharge output voltage2,000 V approx.
Output [Check (CHECK) Error (ERROR) Discharge (DSC)]NPN open-collector transistor
• Maximum sink current: 50 mA
• Applied voltage: 30 V DC or less (between output and 0 V)
• Residual voltage: 1 V or less (at 50 mA sink current)
(Note："DSC" is an abbreviated name of "DISCHARGE".)
Output:Output operationCheck output (CHECK): ON when the discharge needle is dirty or worn, OFF when operation is normal
Error output (ERROR): OFF when abnormal discharge is detected, ON when operation is normal
Discharge output (DSC) (Note): ON when discharging, OFF when discharge halts
(Note) ‘‘DSC’’ is an abbreviated name of ‘‘DISCHARGE’’.
Output:Short-circuit protectionIncorporated
Discharge halt input (DSC OFF)Short-circuit to 0 V: Discharge halt, Open: Discharge allowed (operation start)
(Note："DSC" is an abbreviated name of "DISCHARGE".)
Reset input (RESET)In the state that operation is stopped due to an error detection, open 0 V of the power supply from short-circuit state to cancel ERROR
Indicators:Power (POWER)Green LED (lights up when the power is ON)
Indicators:Discharge (DSC)Green LED (lights up when discharging)
(Note) ‘‘DSC’’ is an abbreviated name of ‘‘DISCHARGE’’.
Indicators:Air monitoring (AIR)Orange LED (lights up when no air is being supplied)
(Note) Discharge halts when lights up.
Indicators:Check (CHECK)Orange LED (lights up when the discharge needle is dirty or worn, etc.)
Indicators:Error (ERROR)Red LED (lights up when abnormal discharge is detected)
Ambient temperature0 to +55 ℃ +32 to +131 ℉ (No dew condensation allowed), Storage: –10 to +65 ℃ +14 to +149 ℉
Ambient humidity35 to 65 % RH (No dew condensation allowed), Storage: 35 to 65 % RH
I/O connectorFor power & input / output: 8-pin connector, For connection: 9-pin connector
Connectable unitsMaximum number of connectable units: 5 (Including this unit)
Enclosure earthingCapacitor earth
MaterialEnclosure: ABS (Nickel plated), Nozzle mount, Screw mount, Nozzle: Stainless steel. Discharge needle: Tungsten
WeightNet weight: 110 g approx., Gross weight: 180 g approx.
AccessoriesConnector attached cable: 1 pc. (length 0.5 m 1.640 ft), End connector (9-pin): 1 pc., Lead wire for connecting F.G.: 1 pc.

MENU

Recently checked products

Recently checked product numbers